Veterans

Categories

Cart  

No products

Shipping $0.00
Tax $0.00
Total $0.00

Cart Check out

Carb Support Bracket for the cn and cfmoto 250

Carb Support Bracket for the cn and cfmoto 250

More details


$48.50 tax excl.


Notify me when available

This support bracket will fit the CN250 and the CFMOTO 250 ,  on the CFMOTO the lower arm on the bracketr will need to be modified or the throttle cable mount will need to be changed to the CN one. 

 

Installation of carb support mount for on a 2005 Hammerhead 250 (CN250 engine):

1 ) Remove the rear cargo cage and gas tank. This was necessary on the Hammerhead in order to access one bolt on the cylinder head. If you remove the gas tank, be sure to turn off the gas valve first.
2 ) Remove three cylinder head bolts - 1 on the picture
3 ) Place head bracket 2 on cylinder head and re-install three cylinder head bolts - 1
4 ) Install rubber bushing on bracket arm 5
5 ) Loosely connect bracket arm 3 to head bracket 2 using two bolts 4 (you will tighten these bolts once the carb is connected)
6 ) Connect the carb to bracket arm using bolt 5
7 ) Once bolt 5 is tight, finish tightening bolts 4
8 ) Reinstall rear cage and gas tank if necessary and don't forget to turn the gas valve back on.

If you have a CN250 type engine with a UNI hanging off of the carb - your manifold gasket will fail - it isn't a matter of if, just a matter of when.